OSRAM e:cue SYMPL pro Node Installationsanleitung Seite 25

To access the web interface, open a common web browser on a connected
PC. Enter the SYMPL pro Node's (e:pix) / SYMPL essential Node's IP
address into the address bar:
e.g. http://192.168.123.1.
Open the Test mode page by selecting "TestMode" on the left side of the
web interface of the SYMPL pro Node (e:pix) / SYMPL essential Node:
Click a button to choose a test pattern. Define the properties:
Property
Output
Channel Count
Block Size
Offset
Value
Step Time
Click "set" to run the test and to apply changes in the test settings.
Description
DMX/RDM ports to run the test on.
Total frame length. Editable in "TestMode e:pix" on
SYMPL pro Node e:pix only.
Block size in which to step through the frame length
in channel count.
Start address of the first test loop (first channel = 1).
Luminance of the test output (0 - 255).
Delay between steps. Manual: Press the Test button
to move the block. Define the first channel at "Start
Address".
- SYMPHOLIGHT v5.0 or higher needed-
25