Identify Button: Identification & Reset - OSRAM e:cue SYMPL pro Node Installationsanleitung

2.4 Identify button: Identification & Reset
The Identify button has three functions: to send an Identify message (A), to
reset the Node (B), and to exit the error state (C). For the e:pix version, the
Identify button additionally switches protocol during Test mode (D).
(A) A short press during operation in online mode sends an Identify
message to the server. This helps to assign the Node in the Setup tab in
SYMPHOLIGHT.
(B) The Identify button can also be used to reset the device to factory state
or to stay in bootloader mode. With a reset you restore the password and
other properties by using the Identify button. Please note that the device
name and the offline content are not reset:
• Keep the Identify button pressed while powering up, Status and
Test / Error LEDs light up at first. Bootloader mode is signaled by a fast
blinking Status LED. Release the button now. The device stays in
bootloader mode to download a new firmware.
To exit the bootloader mode, short press the Identify button again.
• Press the Identify button until Status and Test / Error LEDs blink
alternating, then blink together. Releasing the button now resets the
device to its factory settings. The password and other settings are reset
to their default values. Please note that the Offline Content cannot be
reset. To employ a reset Startup behavior, a restart of the device is
required.
• Keeping the button pressed further on, the device proceeds to
normal operation. No changes apply.
(C) Short press the Identify button if an error occurs and you want to exit
the error mode. The device will switch back to normal activity if the cause of
error is eliminated. The Node might reboot.
(D) e:pix version only: During test mode, single press the Identify button to
switch between e:pix and DMX protocol in the test.
General device description
13