Operation - HANSGROHE Talis S2 32440000 Montageanleitung

Assembly
Important! The fitting must be installed, flushed
and tested after the valid norms.
1. Flush through the supply pipes.
2. Mount the S - unions and align them.
3. Fasten the mixer with the washers.
The hot and cold supplies must be of equal pres-
sures.

Operation

The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
32440000/32443000: The flow is changed from
bath to shower function by pulling the knop at the
upper side of the spout. After shutting off the water
flow, the mixer returns automatically to the bath
function.
Technical Data
Operating pressure:
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.: 65° C
Centre distance:
Connections G ½":
Rate of flow by 0.3 MPa:
Back flow and vacuum breaker
Fault
Insufficient water
Mixer stiff
Mixer dripping
Hot water temperature too low
Instantaneous heater didn't work - Flow limiter in handshower isn't
English
max. 1 MPa
1.6 MPa
max. 80° C
150 ± 16 mm
cold right - hot left
approx. 22 l/min
Cause
- Shower filter seal dirty
- Non return valve hasn't moved
back
- Aerator calcified, dirty
- Cartridge defective, calcified
- Cartridge defective
- Hot water limiter incorrectly set
removed
- Filter are dirty
- Non return valve didn't move
back
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a continuous
flow water heater.
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled con-
tinuous flow heaters if the flow pressure is at least
0.15 MPa.
Attention!
The non return valves must be checked regularly ac-
cording to DIN EN 1717 in accordance with national
or regional regulations (at least once a year).
Spare parts (see page 4)
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 flange 32440000/32640000
6 S-unions 32440000/32640000 94140000
7 aerator cpl.
8 selector assy
9 diverter knob
10 non return valve
Remedy
- Clean filter seal between shower
and hose
- Exchange non return valves
- Clean aerator (s. p. 14), re-
place as necessary
- Exchange cartridge
- Exchange cartridge
- Set hot water limiter
- Remove flow limiter
- Clean the filter / exchange filter
- Exchange non return valves
32096000
96338000
97406000
97209000
92730000
96467000
13914000
97978000
96466000
94074000