Cleaning And Maintenance Of The Cooker Hood; Draining The Appliance - Inventum IKI9045FLOW Benutzerhandbuch

7

Cleaning and maintenance of the cooker hood

DAILY CLEANING
1. Clean the glass valve. Follow the procedure as described for the induction hob. Refer to section
Caution:
Do not clean the glass valve in a dishwasher.
CLEANING THE GREASE COLLECTOR AND THE GREASE FILTER
Note:
The grease filter must be cleaned when the display shows G or at least once a month.
1. Push the slider on the glass valve (A).
2. Remove the glass valve.
3. Remove the grease filter (B).
4. Remove the grease collector (C).
5. Clean the grease collector and the grease filter. Use hot water and a mild cleaning agent.
6. If necessary, clean the grease collector and the grease filter in a dishwasher.
Note:
The grease filter can change color after cleaning. This is normal.

DRAINING THE APPLIANCE

The appliance has a sensor that detects condensation or too much liquid. When the sensor is activated, the cooker
hood automatically switches off. The display flashes 8 for 1 minute.
Drain the liquid to reset the alarm and to use the cooker hood again.
Removing the liquid
1. Put a container below the opening at the bottom of the appliance.
2. Push and hold the lever (A) to drain the liquid.
Dyring the components
After removing the liquid it is important to dry the components inside the appliance.
1. Push the slider on the glass valve (A).
2. Remove the glass valve.
3. Remove the grease filter (B).
4. Remove the grease collector (C).
5. Dry the components. Use a dry tea towel.
CLEANING THE CHARCOAL FILTER (OPTIONAL)
Note:
This procedure is only valid if you installed the charcoal filter with your appliance.
'Daily cleaning'
.
(Figure 6)
(Figure 7)
(Figure 8)
(Figure 9)
(Figure 6)
(Figure 7)
(Figure 8)
English • 35