Herunterladen Inhalt Inhalt Diese Seite drucken

Installing The Cooker Hood - Inventum IKI9045FLOW Installationshandbuch

Einbau-induktionskochfeld mit integriertem abzug
Vorschau ausblenden Andere Handbücher für IKI9045FLOW:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2. Remove the cover (A).
3. Remove the screws.
4. Loosen the plastic locking pin. Use a screwdriver.
5. Remove the extension together with the duct adapter marked 1 (B).
Replacing the duct adapter
1. Remove the screws.
2. Remove the duct adapter marked 1 from the extension (C).
3. Attach the duct adapter marked 2 to the extension. Use the screws.
Installing duct adapter 2
1. Put the plastic locking pin in the opening.
2. Attach the extension together with the duct adapter marked 2 (D).
3. Install the cover (E). Use the screws.

INSTALLING THE COOKER HOOD

Caution:
For kitchen cabinets with a depth up to 750 mm or with a depth of more than 810 mm, it is necessary to
replace the duct adapter before installing the cooker hood. Refer to section
1. Put the cooker hood (A) in the kitchen cabinet.
2. Attach the cooker hood to the duct. Use the screws.
3. Install the cover (B). Use the screws.
4. Install the joint for the pipes (C). Use the screws.
INSTALLING THE ELECTRICAL CONNECTIONS
1. Connect the connectors for the controls (A).
2. Connect the connectors for the sensor (B).
3. Install the mains plug for the two mains cables of the induction hob.
Note:
The mains cable of the cooker hood is supplied with a mains plug.
INSTALLING THE FILTERING KIT (OPTIONAL)
1. Prepare the plinth of the kitchen cabinet according to the dimensions of the box for the filter.
Note:
Make sure that the grid and the filter are removed.
2. Connect one side of the flexible pipe (A) to the joint (B) on the cooker hood. Use the tape.
3. Connect the other side of the flexible pipe to the box of the filter (C). Use the tape.
4. Install the box of the filter to the cabinet:
a. Use the knobs to fit the box between the cabinet and the floor.
b. Use the screws to attach the box directly to the cabinet.
5. Put the carbon filter (D) in the box of the filter.
6. Install the grid (E).
26
English
(Figure 13)
(Figure 14)
(Figure 15)
(Figure 16)
(Figure 17)
'Replacing the duct adapter'
(Figure 18)
(Figure 19)
(Figure 20)
(Figure 21)
(Figure 22)
(Figure 23)
(Figure 24)
(Figure 25)
.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis