Overview Of The Components; Using The Appliance - BOMANN bs 970 cb Bedienungsanleitung

1 Vacuum hose
2 Hose connection
3 Telescopic suction tube
4 Coupling
5 Button for releasing the
new dust container
6 Dust container with fi lter insert
7 On/off switch
8 Parking assistance
• Insert the connection head of the suction hose into the hose connector until it
locks in place. To do so, please press the buttons simultaneously. In order to
release the hose again, please press the buttons once more on the connection
head.
• Keep the buttons pressed down and then pull out the hose.
• Insert the vacuum tube into the handle if required.
1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Vacuum at a steady speed. There is no need to exert pressure.
4. Attention: pay attention to the range that can be covered with the cable
length.
Cable winding device
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the cable to avoid
wrapping.
05-BS 1247 neu 61

Overview of the Components

Start-up

Using the Appliance

9 Floor nozzle
10 Cable-winding key
11 Carrying handle
12 Air slide (not shown)
13 Cover of outlet fi lter
Accessories:
„2-in-1" nozzle
(groove and brush nozzle)
GB
61
20.10.2005, 9:01:30 Uhr