Makita DHR400 Betriebsanleitung Seite 17

Description of the wireless activation lamp status
► Fig.39: 1. Wireless activation lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the table below for the
meaning of the lamp status.
Status
Color
Standby
Blue
Tool
Green
registration
Cancelling Red
tool
registration
Others Red
Off
Cancelling tool registration for the
vacuum cleaner
Perform the following procedure when cancelling the
tool registration for the vacuum cleaner.
1. Install the batteries to the vacuum cleaner and the
tool.
Set the stand-by switch on the vacuum cleaner to
2.
"AUTO".
► Fig.40: 1. Stand-by switch
3. Press the wireless activation button on the vac-
uum cleaner for 6 seconds. The wireless activation
lamp blinks in green and then become red. After that,
press the wireless activation button on the tool in the
same way.
► Fig.41: 1. Wireless activation button 2. Wireless
activation lamp
If the cancellation is performed successfully, the wire-
less activation lamps will light up in red for 2 seconds
and start blinking in blue.
NOTE: The wireless activation lamps finish blinking in
red after 20 seconds elapsed. Press the wireless acti-
vation button on the tool while the wireless activation
lamp on the cleaner is blinking. If the wireless acti-
vation lamp does not blink in red, push the wireless
activation button briefly and hold it down again.
Wireless activation lamp
On Blinking
-
Duration
The wireless activation of the vacuum cleaner is available. The
2 hours
lamp will automatically turn off when no operation is performed
for 2 hours.
The wireless activation of the vacuum cleaner is available and the
When
the tool is tool is running.
running.
20 seconds Ready for the tool registration. Waiting for the registration by the
vacuum cleaner.
The tool registration has been finished. The wireless activation
2 seconds
lamp will start blinking in blue.
20 seconds Ready for the cancellation of the tool registration. Waiting for the
cancellation by the vacuum cleaner.
The cancellation of the tool registration has been finished. The
2 seconds
wireless activation lamp will start blinking in blue.
The power is supplied to the wireless unit and the wireless activa-
3 seconds
tion function is starting up.
The wireless activation of the vacuum cleaner is stopped.
-
17 ENGLISH
Description