Cable Assignment - ICP ICARUS Serie Handbuch

RX HEAVY
Second category errors:
Second category errors lead immediate system shutdown to prevent
possible operational faults. If the cause of the error has been found
and repaired, the error display can also be reset.
To do this, please disconnect the receiver from the power supply and
connect it again. If the error has been successfully dealt with, the
POWER LED lights up again in green and operation can be continued.
If the error is still present, the receiver switches itself off again
immediately and displays the error code once more.
POWER LED is flashing: Meaning:
6 times Input voltage below 8V
8 times Input voltage above 38V
9 times Overcurrent (main controller)
10 times High or low voltage (main controller)
11 times Error in an output (see output LEDs)
If your receiver does not function although no error is displayed, it may be
because the radio signal sent by the transmitter is not reaching the receiver.
(When a key is pressed on the transmitter, the RF LED DOES NOT light up)
I. Ensure that the distance between the transmitter
and receiver is not greater than 50 metres.
II. Ensure that there are as few objects as possible, particularly
metallic objects, between the transmitter and the receiver.
III. If you are surrounded by a metallic grating or another
heavy metallic structure, please leave these surroundings.
IV. Check if there are transmission masts in the immediate vicinity,
which could lead to faults, and if necessary leave this area.
V. Check if there are cables in the immediate vicinity carrying
high voltage or current and leave these surroundings if necessary.
If the receiver still does not work correctly after carrying out these steps,
please contact your supplier.
124

4.10 CAbLE ASSIGNMENT

function: Number/Colour:
0Vdc yellow/green
12-24Vdc 1
In 1 2
In 2 3
System active 4
Out 0 (Pump) 5
Out 1 6
Out 2 7
Out 3 8
Out 4 9
Out 5 10
Out 6 11
Out 7 12
Out 8 13
Out 9 14
Out 10 15
Out 11 16
Out 12 17
RX HEAVY
125