Commissioning Of The Receiver; Operation; Assembly Regulations; Assembly Guidelines - ICP ICARUS Serie Handbuch

RX MINI

2.3 CoMMISSIoNING of THE RECEIVER

Supply operating voltage to the receiver (9-30V DC)
and log on the transmitter as per the description (2.11).

2.4 oPERATIoN

I. Ensure the power supply of the receiver (9-30V DC). LED 1 flashes green.
II. Push up the red „power switch" on the back of the transmitter (TX MINI)
or pull out the emergency stop switch (TX HEAVY).
III. Press any button on the transmitter
IV. System ready for use (LED 1 CONSTANTLY ON)
If the transmitter is not activated for longer than 15 minutes (standard
setting) it turns itself off automatically to save energy. The receiver is
deactivated at the same time (LED 1 flashes green). To reactivate the
receiver, proceed as described above.

2.5 ASSEMbLY REGULATIoNS

I. Before installation and assembly of the receiver, check that it is working correctly.
II. Before installation and assembly, separate the receiver from the mains.
III. If possible, secure the receiver within visual range of the end user.
IV. Do not fit near motors, relays or power cables.
V. Fit receivers with internal antennae outside the metal housing.
VI. You must observe the circuit diagram and ensure that it is followed.
VII. After assembly check each function of the receiver before
it is used in the normal working environment.
104
4 × Assembly holes

2.6 ASSEMbLY GUIDELINES

Fix the receiver with four fixing screws (M5, length as required).
The maximum torque for the fixing screws
must not be exceed 3.5 Nm during assembly.
66

2.7 CLEANING INSTRUCTIoNS

The receiver should only be cleaned with a damp cloth and without chemicals.

2.8 CARE AND MAINTENANCE

We recommend that you clean the receiver weekly as described in the previous section
(damp cloth, no chemicals). If the receiver is used in a very dirty, e.g. dusty, environment,
we recommend that you clean it every day to avoid possible resulting damage.
RX MINI
4 × Assembly holes
Ø 5,5mm
105