Operation; Changing Batteries - ICP ICARUS Serie Handbuch

TX MINI

1.3 oPERATIoN

I. Ensure the power supply to the receiver (24V DC)
II. Push the red „power switch" on the back of the transmitter up.
POWER LED flashes green.
III. Press any button on the transmitter
IV. Transmitter ready for use (POWER LED CONSTANTLY ON)
If the transmitter is not activated for longer than 15 minutes (standard setting)
it turns itself off automatically to save energy. To use again, please push
the power switch on the back down and start again at point two (see above).
Please note: If the transmitter has turned itself off automatically it uses less energy,
but still more than when the power switch has been pushed down!
If the transmitter is not used for a prolonged period,
please remove the batteries to avoid corrosion and resulting damage,
and to avoid the batteries losing charge!
Power switch down:
Transmitter off
96
Power switch up:
Transmitter on

1.4 CHANGING bATTERIES

The manual devices in the ICARUS family can be equipped with conventional batteries
or rechargeable batteries as desired. A transmitter equipped with rechargeable batteries
can be charged at any time with the charger that is available as an accessory. During the
charging procedure the BATTERY LED is constantly lit. As soon as this is no longer lit,
the rechargeable battery has been charged and is ready for use.
To change conventional batteries or rechargeable batteries, proceed as follows:
I. Turn the locking screw on the battery compartment anti-clockwise
II. Remove the battery compartment cover
III. Remove the old batteries
IV. Insert 3 AA batteries in the specified direction
V. Put on the battery compartment cover and close
VI. Turn the locking screw on the battery compartment clockwise
(max. 0.1Nm torque to prevent damage to the housing)
I.
III.
V.
TX MINI
II.
IV.
VI.
97