Operation; Changing Batteries - ICP ICARUS Serie Handbuch

TX HEAVY

3.3 oPERATIoN

I. Ensure the power supply of the receiver.
II. Pull out the emergency stop switch of the transmitter.
III. Press any button on the transmitter
IV. Transmitter ready for use
If the transmitter is not activated for longer than 15 minutes (standard setting)
it turns itself off automatically to save energy. To use again, please press the
emergency stop switch and start again at point two (see above).
Please note: If the transmitter has turned itself off automatically it uses less energy,
but still more than when the emergency stop switch has been pressed!
If the transmitter is not used for a prolonged period,
please remove the batteries to avoid corrosion and resulting damage,
and to avoid the batteries losing charge!
Emergency stop
Pushed in:
Transmitter off
Pulled out:
Transmitter on
112

3.4 CHANGING bATTERIES

The manual devices in the ICARUS family can be equipped with conventional batteries
or rechargeable batteries as desired. A transmitter equipped with rechargeable batteries
can be charged at any time with the charger that is available as an accessory. During the
charging procedure the BATTERY LED is constantly lit. As soon as this is no longer lit,
the rechargeable battery has been charged and is ready for use.
To change conventional batteries or rechargeable batteries, proceed as follows:
I. Turn the locking screw of the battery compartment anti-clockwise
(on the bottom of the transmitter)
II. Take the battery holder out of the transmitter
III. Remove the old batteries
IV. Insert 6 AA batteries in the specified direction
V. Push the battery holder back into the transmitter
VI. Turn the locking screw on the battery compartment clockwise
(max. 0.1Nm torque to prevent damage to the housing)
I.
III.
V.
TX HEAVY
II.
IV.
VI.
113