Transmitter Logon And Logoff - ICP ICARUS Serie Handbuch

RX MINI

2.11 TRANSMITTER LoGoN AND LoGoff

To log on a new or additional transmitter, learning mode must be activated.
Proceed as follows:
I. Ensure that the receiver is connected to a voltage source (9-30V DC).
II. Wait for at least 5 seconds and then press the SET button on
the receiver three times and holding it down the third time.
III. Learning mode is now active as long as the SET button is held down.
(LED 1 flashes quickly (green))
If learning mode is activated, transmitters can be logged on and off.
Logging on a transmitter:
I. Activate learning mode and hold down the SET button. (see above)
II. Pull out the emergency stop switch of the (TX HEAVY) or push up
the power switch of the transmitter (TX MINI) (ON).
III. Press Function key 1 on the transmitter until LED 2 lights up in green.
The transmitter is now logged on.
To log on a further remote control, please repeat the procedure from
step two with the other transmitter. (Hold down the SET button!)
To deactivate learning mode, release the SET button of
the receiver after logging on a transmitter.
Logging off a transmitter:
I. Activate learning mode (see above)
II. Pull out the emergency stop switch of the (TX HEAVY) or push
up the power switch of the transmitter (TX MINI) (ON).
III. Press Function key 2. LED 2 lights up in red when the key is pressed.
The transmitter is now logged off.
To log off a further remote control, please repeat the procedure from
step two with the other transmitter. (Hold down the SET button!)
To deactivate learning mode, release the SET button
of the receiver after logging off a transmitter.
108
Set-Button
RX MINI
109