ESX VE1200.5 Bedienungsanleitung Seite 17

LOUDSPEAKER WIRING & CONNECTION
3-CHANNEL-MODE: 2 Speakers / Stereo & 1 Subwoofer / Mono bridged
4 OHM
SUBWOOFER
Interconnect Cable Checklist
• Connect the RCA Outputs (FRONT L & R und REAR L & R) of the head unit with the RCA Inputs (CH1 & CH2 / CH3 & CH4) of the
Amplifier by using appropriate RCA Cables.
• Connect the Speakers and the Subwoofer with the Speaker Outputs (+ 1CH & - 2CH / + 3CH & - 4CH and + Mono -).
• The minimum final speaker impedance should not be lower on CH1/2/3/4 than 2 Ohms and on CH5 1 Ohms per Channel.
Input Gain
• Turn the INPUT GAIN-Control (T5 & T7) on 9V-Position (Channel 1 & 2 / 3 & 4) and the F2-Control on 6V-Position(Channel 5).
• Turn the the head unit volume to about 80-90% of its full setting.
• Turn the INPUT GAIN-Control (T5 & T7 & F8) counter clockwise until you hear some distortion.
• Then turn back the INPUT GAIN-Control (T5 & T7 & F8) slightly until you can here clean sound.
Configuration Speakers Channel 1 & 2
• When you use bigger speaker systems (20cm) the Input Selector should be set on FULL-Position (Full Range-Signal).
• When you use smaller speaker systems (8.7cm - 16cm) the Input Selector should be set on HIGH PASS-Postion,because too low
• frequencies can cause damages to your speakers.The cut-off frequency should be between 60Hz - 150Hz depending on the size of the
• installed speakers and it is continously variable from 10 Hz up to 2500 Hz via Highpass-Control T6.
• When T9 is set on BP-Position the ower and upper frequency of the Bandpass Signal is adjustable by T6 & T8. See page 18!
Configuration Channel 5
Please see the previous page.
5-Channel Amplifier VE1200.5
2 OHM
2 OHM
2 CH
1CH
Head Unit
17
MIN MAX
LEVEL
BASS REMOTE
MIN - MAX Level Controller
White LED = Operation Mode
Red LED = Protection Mode (see page 19)