ESX VE1200.5 Bedienungsanleitung Seite 13

FUNCTIONS & CONTROLS FRONT-PANEL / REAR-PANEL
F1
LINE OUTPUT
Provides a full range line level (RCA) output that allows you to trigger additional amplifiers.
F2
INPUT GAIN (5CH / Digital Amplifier Section)
Controls the Input Sensitivity of Channel 5 between 0,15 Volts and 6 Volts.
F3
BASS BOOST (5CH / Digital Amplifier Section)
Allows you to adjust the BASS BOOST of Channel 5 from 0 up to 18 dB. Please use the Bass Boost carefully.
F4
LOW PASS (5CH / Digital Amplifier Section)
Controls the cut-off frequency of the lowpass, that means the frequency response is limited upwards.
The cut-off frequency is continously variable from 40 Hz up to 4000 Hz.
F5
SUBSONIC (5CH / Digital Amplifier Section)
Controls the lower cut-off frequency of the lowpass, that means the frequency response is limited downwards
The cut-off frequency is continously variable from 10 Hz up to 50 Hz.
F6
PHASE SHIFT (5CH / Digital Amplifier Section)
Controls the Phase Shift of Channel 5 between 0 - 180 degrees.
F7
REMOTE
Connection for Remote Control to adjust the Subwoofer Level from your seat.
F8
INPUT SELECTOR
Allows to choose between a 2-Channel, 4-Channel, 5-Channel Inputsignal.
R1
FUSE
Fuse block for the internal device protection. Attend the notes on page 11!
R2
REM
Terminal for Remote turn on/off of the head unit. Attend the notes on page 12!
R3
BATT +12V
Terminal for plus connection of the battery. Attend the notes on page 12!
R4
GROUND
Terminal for ground connection (Minus terminal). Attend the notes on page 12!
R5
SPEAKER OUTPUT
Terminals for loudspeakers. Attend the several examples of connections on the following pages!
5-Channel Amplifer VE1200.5
R5
13