Setting Up The Machine; Setting The Unit Of Length (Mm Or Inch) - Weidmuller Power Stripper Serie Originalbetriebsanleitung

5

Setting up the machine

The machine has to be set up in the following situations:
– Every time the machine is put into operation.
During set-up, the following settings must be checked and
adjusted if necessary:
– Unit of length
– Cross section
– Stripping length
– Draw-off length
Symbols on the front side using the control knobs:
Symbol Meaning
Stripping length
Draw-off length
2562260000/01/10.2017

5.1 Setting the unit of length (mm or inch)

► Briefly press the touch display.
The hand symbol appears.
► Keep the touch display pressed for 5 seconds.
The unit of length changes.
Figure 5.1 Display with the unit of length in millimetres
Figure 5.2 Display with the unit of length in inches
25