Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Starting locomotive operation
Vehicles arrangement: see fig. 3
Operating instructions: Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is R2 of
the FLEISCHMANN track system (R2 = 225,2 mm).
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 6595, FLEISCHMANN track cleaning rubber.
10
Fittings: In the enclosed accessory bag you will
find small kits to be fitted on your locomotive.
Please mount them cautiously.
Attention! Use glue only if indicated (fig. 1).
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface as
shown in fig. 4, pay attention to the markings „1".
GB
Maintenance of the model
To enjoy your model for a long time, it is necesary
to service it regulary (i.e. after it has been in ope-
ration for approximately 30 hours).
1. Lubrication: Apply tiny oil drops to spots
marked in fig. 5. Prior to lubrication dismantle lo-
comotive (fig. 2).
We recommend using item no. 6599, Fleischmann
oiler.
2. Change of traction tyre: Take out wheel
set and remove traction tyre using a pin or a
fine screwdriver (fig. 6). When pressing on the
new traction tyre please avoid twisting it.
5. Carbon Brush Changing: First remove loco
body (fig. 2), and then the motor (fig. 7).
3
Werbung
