Herunterladen Inhalt Inhalt Diese Seite drucken

Electrical Installation Rules - LaCimbali ELECTIVE Gebrauch Und Installation

Vorschau ausblenden Andere Handbücher für ELECTIVE:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 87
2.2 Installation Rules
Before plugging in the machine, make sure that the information on the nameplate (voltage, etc.)
matches that of the electrical.
Check the condition of the power supply cord; if it is damaged it must be replaced.
Completely unwind the power-supply cable.
The machine should sit on a at and stable surface
Room temperature must range between 10 and 32 °C (50 and 90 °F).
An electrical outlet must be in the immediate vicinity.
Do not install in rooms (kitchens) that are cleaned with jets of water.
Do not obstruct openings or ventilation and heat vents.
Do not install the machine outdoors.
Do not install or use the appliance in potentially explosive environments.
Do not install the appliance in the presence of ammable substances

3. Electrical Installation Rules

Prior to installation, make sure there is a circuit breaker installed with a distance between the contacts
that allows for complete disconnection when there is a category III overload and that provides
protection against current leakage equal to 30 mA. The circuit breaker must be installed on the power
supply in compliance with installation rules.
The electrical safety of this machine is only ensured when it is correctly connected to an efficient earthing system in
compliance with the electrical safety laws in force This fundamental safety requirement must be verified If in doubt,
request that a qualified electrician inspect the system The manufacturer cannot be held responsible for any damage
caused by the lack of an earthing system on the electrical supply.
Do not use adaptors, multiple plugs, and/or extension cords.
Check that the type of connection and voltage correspond with the information on the nameplate.
4. Positioning the hopper
After removing the packing materials, place the
receptacle (2) on the grinder and fasten it using
the ring nut (A).
Note. The hopper may ONLY be removed or
positioned when the shutter is closed.
e grinder onl wor s w en t e
ring nut A
as been completel
tightened.
2
4 EN
A

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Elective tamper

Inhaltsverzeichnis