Using The Battery Pack; Battery Level Display - Samsung DVD-L100W Bedienungsanleitung

E N G L I S H

Using the battery pack

Important!
• When inserting the battery pack, make sure that it is inserted correctly.
Otherwise, your DVD player may malfunction.
Charging the battery pack
Use the AC adapter (included) to charge the battery pack.
• Before charging, make sure that the battery pack is correctly seated.
1. Connect the AC cord to the jack on the AC adapter ( ).
2. Plug the other end of the AC cord into an AC outlet ( ).
3. Connect the DC cord to the DC IN jack on the left side of the DVD player ( ).
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50%~75%
Three times per second 75%~90%
Blinking stops and stays on 90%~100%
On for a second and Error-Reset the battery pack and
off for a second the DC cable
Power Charge Lamp
-Green light will flash while charging.
-When the battery pack is charged, the light will stop blinking and remains green.
24
Downloaded from www.Manualslib.com manuals search engine

Battery level display

• The battery level display indicates the amount of power remaining in the battery pack.
a. Fully charged
b. 20~40% used
c. 40~80% used
d. Completely used (flickers)
(The DVD will turn off soon, change the battery as soon as possible)
The playing times is affected by environmental temperature and conditions.
The playing times becomes very short in a cold environment. The continuous playing times in the operating instructions are
measured using a fully charged battery pack at 25°C. As the environmental temperature and conditions may differ when
you actually use the DVD, the remaining battery time may not be the same as the approximate continuous
playing times given in these instructions.
E N G L I S H
...........................a
...........................b
...........................c
...........................d
25