Grundig MGK 6841 Bedienungsanleitung Seite 23

OPERATION_______________________________
Cutting_hair
Please use the T blade and
1
If necessary, remove the attachment
by holding the head and pushed
away from the appliance.
2_
Insert stainless steel cutting head
carefully at the top and press down
until it clicks into place.
3 Place a towel around the neck and
shoulders of the person whose hair
you are trimming.
4_ Make sure the person is seated so
that their head is roughly at your eye
level. Before trimming, comb the hair
so that it falls naturally and you can
see the direction in which it grows.
5 Press the B button to switch on the
appliance and start cutting your hair.
B
6 Press the button to switch off the
appliance after use.
Beard_trimming
Please use the beard trimming attach-
ment.
1
If necessary, remove the attachment
by holding the head and pushed
away from the appliance.
2
Insert beard trimming attachment
carefully at the top and press down
until it clicks into place.
3
comb 3.
4
5
Trimming_hair_or_beard_to_
a_certain_length
Please use the attachments.
1
2
Note
7
Comb attachment 1
fitting with U blade
Comb attachment 2
fitting with U blade
Comb attachment 3
fitting with T blade
Loosen the beard hair by combing
the beard in the direction the hair
grows.
Press the button to switch on the
appliance and start trimming your
beard.
Press the button to switch off the
appliance after use.
If necessary, remove the attachment
by holding the head and pushed
away from the appliance.
Insert attachment (U trimmer) or
(T trimmer) carefully at the top and
press down until it clicks into place.
The comb attachments fit both cutting
heads.
1.0, 1.5, 2.0
mm
4, 6, 9, 12,
18 mm
13, 15, 17,
19, 21, 23
mm
ENGLISH 23