Operating The Appliance - VINCENT solidLine CD-S5 Bedienungsanleitung

Operation
Switch on and off
Change the level of the
analogue audio outputs
(10) at the rear panel
Change the brightness
of the front panel
display
Operation
Start and pause
playback
Insert/Change the CD
Vincent
36

OPERATING THE APPLIANCE

BASIC FUNCTIONS AND SETTINGS
Button(s) Description
The amplifier is switched on and off using this button at the front panel.
When switched off the device is internally not separated from the AC power
and reacts to a "POWER CONTROL" (12) switching signal. The appliance
POWER (3)
can not be switched on/off as long as a cable is connected to one of the
jacks "POWER CONTROL". As a precaution, before switching on, the volu-
me setting of your system's preamplifier should be reduced.
This function may only be activated with the remote control and only during
playback. This control is to allow the adaptation of the player to the system
(mainly the amplifier) and it must not be used to change the volume of the
CD player in daily use. It is sufficient for almost all amplifiers/receivers/pre
stages to put the setting to the maximum and to leave it there. A different
value is only used if the CD player is much louder compared with the other
VOL+ (30)
sources at the amplifier/receiver or it is distorted (clipping). Hold down the
VOL- (31)
"VOL+" button to raise the output level. Use the "VOL-" to reduce it. The two-
figure value of the volume appears in the display (1). The maximum signal
level is reached with a setting of 26 and the minimum is at 00. This volume
control changes the output level of all analogue outputs to the same extent.
In order to decode HDCDs properly, this setting must be set to the maximum
"26" when playing a HDCD!
This function can only be operated using the associated front panel button.
DIMMER (14) When repeatedly pressed, the display (1) brightness is periodically reduced
(1x), switched off (2x) and restored to the original, maximum brightness (3x).
PLAYBACK FUNCTIONS
Button(s) Description
This button, both on the front of the device and on the remote control,
starts playing the inserted CD and the symbol "
(1) during play. If there is no CD inserted, "NO DISC" appears in the dis-
(7)(20) play and pressing the button has no effect. If the button is pressed again
PLAY/ while a CD is playing, play will be interrupted at the current position. This
PAUSE "PAUSE" mode is indicated in the display by the symbol " ". During the
pause the disc continues to rotate and when the button is pressed play
continues from this position. The "PAUSE" function should only be used for
brief interruptions.
With this button you open and close the disc tray so that a CD can be
inserted or removed. This button is located both on the front of the device
(9)(24)
and on the remote control. If the text "OVER" appears in the display (1),
OPEN/
then the CD contains more than 16 tracks. Some of the tracks cannot then
CLOSE
be shown in the display's music menu.
appears on the display