ATH-Heinl Flex Lift 30 Bedienungsanleitung Seite 63

Operation instruction
The product is intended for lifting of vehicles the respective technical data of the lift have to be attended.
1. Placing of lift
a. Push the button „lifting" to be able to install both rolls of the moving set. Take care that
they are in the correct position on the crossbeam.
b. Lower the lift completely with the button „lowering", thereby the back part of the lift places
automatically on the rolls.
c. Place the front adapter of the drawbar on the lift.
d. Position the control box on the platform and fix it if necessary while moving the lift.
e. Lock the ramps.
f. Now you can lift in front the lift with the drawbar and move the lift. Pay always attention to
the control box.
g. Place the lift at a suitable location.
h. For placing the lift ready for operation follow the items a. – g. in reverse order.
2. Preparation
a. Read all safety instructions carefully before operating the lift.
b. Control of the ground clearance of the vehicle.
c. Place the vehicle central to the lift and drive on. Take care of the load distribution.
d. Place the suitable rubber disks on the platform of the lift. Pay attention that those are
central under the lifting points of the vehicle.
3. Lifting
a. Switch on the lift with the main switch
b. Lift the vehicle until a height of 100-150mm and stop the lifting by releasing the button
"Lifting".
c. Check if the vehicle stands safely on the lift and that the safety notches are activated.
d. Following lift further and observe the lifting process.
4. Lowering
a. Before lowering check if there are objects under the vehicle or the lift.
b. Press the lowering button, the lift will lift a few seconds, unlock the notches and then lowers
5. Termination
a. Remove the rubber disks from the lift.
b. Drive the vehicle off the lift.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Manufacturer ATH-Heinl GmbH & CO.KG
- 17 -