Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX Mode
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows ADDR. You can now set the desired address (A001 - A512)
via the UP or DOWN buttons.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Please, be sure that you don't have any overlapping channels in order to control each fixture correctly and
independently from any other fixture on the DMX-chain. If several fixtures are addressed similarly, they will
work synchronically.
DMX-Protocol
Channel
DMX Value
000-000
CH1
001-255
CH2
000-255
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse-holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse-holder.
Step 3: Install the new fuse in the fuse-holder.
Step 4: Replace the fuse-holder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
No function
Gradual adjustment of the dimmer intensity from 0 to 100 %
Strobe-effect with increasing speed
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
Characteristic
22/23
00100285.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
