Märklin H0 76495 Bedienungsanleitung Seite 12

CV for fx (MM) and DCC
With fx (MM) the address can be set only with the DIP switches.
The values in parentheses are factory default settings.
CV Meaning
1 Address 1 - 255
9 Addresses 256 - 2040
33 Numer of output
addresses
40 Meaning Lighting
PoM*
45 Signal Type Home signal:
76495
PoM*
76497
76496
46 Signal Type Distant Signal
PoM*
48 Home Signal
Switching duration
PoM*
LED on/off
12
Values
1-255 (1) only DCC
0-7 (0) only DCC
— read only DCC
0 - 15 (15) 0 light off
Dimming 0-15,
whereby 15 = 100%
brightness
2 Block signal
3 Entry signal
4 Exit signal
belongs to
Block signal
2
Entry signal
3
Exit signal
4
0 - 3 0 = 0 seconds
1 = 0.175 seconds
2 = 0.35 seconds
3 = 0.5 seconds
CV Meaning
50 Cross fading behavior
Home signal
PoM*
52 Distant Signal
Switching duration
PoM*
LED on/off
54 Cross fading behavior
Distant Signal
PoM*
55 Distant Signal Address,
short (like CV1)
only DCC
56 Distant Signal Address,
long (like CV9)
only DCC
*PoM programming can be done on the main track as long as it
is supported by the control device.
Setting and Calculating Addresses Greater than 255 (DCC):
Example: Address 1044 -> 1044 : 256 = 4.078125. The value before
the decimal point (4) is entered in CV 9. The value after the
decimal point (0.078125) is multiplied by 256 0.078125 x 256 = 20.
The calculated value of 20 must be entered in CV 1.
Values
0 - 3 0 = simultaneously
1 = one after the other
2 = one after the other
0.1 sec. pause
3 = one after the other
0.5 sec. pause
0 - 3 0 = 0 seconds
1 = 0.175 seconds
2 = 0.35 seconds
3 = 0.5 seconds
0 - 3 0 = simultaneously
1 = one after the other
2 = one after the other
0.1 sec. pause
3 = one after the other
0.5 sec. pause
enter the value of the
home signal belonging
to it (only DCC)
enter the value of the
home signal belonging
to it (only DCC)