Osprey SOELDEN PRO Handbuch Seite 8

CORRECT ATTACHMENT AND SETTINGS
7
HOW TO ADJUST THE TRIGGER HANDLE
Adjust the height of the trigger handle
1
on the shoulder strap. There are three
different settings. The trigger handle
should ideally be at chest height.
Always fasten hipbelt, sternum strap and leg loop. The OSPREY ALPRIDE E1 AIRBAG SYSTEM will only be of use to you if the backpack stays
on your body during an emergency!
WARNING: Do not use the OSPREY ALPRIDE E1 AIRBAG SYSTEM without the pack's leg loop engaged.
Osprey Packs, Inc. shall not be liable for any damages and losses due to incorrect set up, incorrect fitting or incorrect adjustments.
OSPREY / ALPRIDE E1 AIRBAG SYSTEM | Owners Manual
Turn up the trigger handle to Then slide the trigger handle
2 3
change the height position out of the webbing loop
accordingly and slide it back
into the correct height.
PACK FIT
LEG LOOP
1
Put the pack on and bring the leg strap from behind
between the legs and to the front of the body. Thread
one side of the hipbelt buckle through the loop at the
end of the leg loop.
3
TIGHTEN HARNESS
Tighten the shoulder harness straps
to tension by pulling down and back.
5
STERNUM STRAP
Buckle and tighten the sternum strap to tension.
HIPBELT
2
With the leg loop threaded onto the hipbelt, engage the
hipbelt buckle. Tighten the hipbelt snugly and evenly over
the top of the hipbone. The majority of the weight of the
pack should rest on the hipbones.
4
TIGHTEN LOAD LIFTERS
Tighten the load lifters to tension
by pulling them up and forward.
English | 15