Harman Kardon HKTS 20 Bedienungsanleitung Seite 8

Left
Surround
Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output
Use this installation method for receivers and preamp/processors that have a dedicated
subwoofer output with low-pass filtering (also called bass management). If the dedicated
subwoofer output does not have low-pass filtering, follow the instructions in Connecting
the Subwoofer to a Receiver or Preamp/Processor With Line Outputs, on page 9.
Use the LFE (purple) connector of the supplied combination LFE and trigger cable to
connect the HKTS200SUB's Line-Level LFE In Jack
(or LFE output) of your receiver or preamp/processor.
0165CSK - HK HKTS20 and HKTS30 v6.indd 8
Downloaded from www.Manualslib.com
Left Front
Front Left
Speaker Cable
(White Bands)
– +
FRONT SURROUND
+ –
RIGHT
LEFT
+ – + –
Receiver
Surround Left
Speaker Cable
(Blue Bands)
– +
to the dedicated subwoofer output
5
manuals search engine
Center
Center
Speaker Cable
(Green Bands)
– +
CENTER
+ –
SUB
LFE OUT
LFE/Trigger Cable
(Purple Ends)
Surround Right
Speaker Cable
(Gray Bands)
Connect each satellite speaker and the center speaker to the corresponding speaker
terminals on your receiver or amplifier.
In your receiver or preamp/processor's setup menu, configure it for Subwoofer ON, and
set the front left, front right, center, and surround speakers to Small. After you have made
and verified all connections, plug the HKTS200SUB's AC Power Cord
outlet.
8 8
Right Front
Front Right
Speaker Cable
(Red Bands)
– +
PL0004-01001
Subwoofer
PL0004-01001
– +
Right
Surround
8
into an active AC
08/10/09 13:32:03