Harman Kardon HKTS 20 Bedienungsanleitung Seite 6

NOTE: If you're running the speaker wire through the wall you can bring it out directly
behind the bracket location and insert it through the bottom opening in the wall portion
of the wall-mount, as shown in the illustration. This will keep the wire completely hidden
from view once the installation is complete.
5. If you're not running the speaker wire through the wall, insert it through the wall portion
of the wall-mount bracket as shown in the illustration.
6. Pass the speaker wire through the speaker portion of the wall-mount as shown in the
illustration.
7. If you have not already removed the speaker's base, do so by pulling it straight off the
speaker, as shown in the illustration. Applying even pressure to both sides of the base
will allow it to slide off smoothly.
CAUTION: Before making speaker connections, be sure that your receiver or amplifier
is turned OFF and preferably, its AC cord is unplugged from the AC outlet.
0165CSK - HK HKTS20 and HKTS30 v6.indd 6
Downloaded from www.Manualslib.com
Insert Wire into
Bottom Opening
Bring Wire Out
through Here
Bring Wire In
through Here
Bring Wire Out
through Here
Apply Pressure Evenly Lift Base Straight
to Both Sides of Base off Speaker
manuals search engine
8. Connect the speaker wire to the speaker terminals as shown in the illustration:
a) Press down on the top of the terminal to open the connection hole.
b) Insert the wire's bare end all the way into the hole.
c) Release the terminal to secure the wire.
Insert the conductor with the colored band into the speaker's red ( + ) terminal, and
insert the other conductor into the speaker's black ( – ) terminal.
+
A. Push Down on Cap to B. Insert Bare Wire into
Open Hole Open Hole
IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch each other or the
other terminal. Touching wires can cause a short circuit that can damage your receiver
or amplifier.
9. Slide the speaker portion of wall-mount onto the speaker as shown in the illustration. Fit
the grooves on the mount onto the rails in the speaker, and apply even pressure on
both sides of the mount so it slides straight onto the speaker.
• Push the mount all the way onto the speaker until it snaps into place.
• Pull any slack speaker wire back through the mount as you slide the mount onto the
speaker.
Fit Bracket Grooves
onto Speaker Rails
10. Slide the speaker onto the mount's wall section as shown in the illustration. Pull any slack
speaker wire back through the mount's wall section.
Slide Speaker
onto Wall-Mount
11. Fit the metal stop plate into the recess on the bottom of the mount with the pad facing
the mount, and fasten it to the mount using two of the supplied screws. This will
prevent The speaker from detaching from the bracket and will hold the speaker's
position as you rotate it on the mount.
Stop Plate
Supplied Screws
6 6
–
C. Release Cap to Secure Wire
Push Down Evenly on Both Sides of Bracket
08/10/09 13:31:57