Dell M8428-k Handbuch Zum Einstieg Seite 9

d. Click OK.
e. From the COM Port Properties window, select the following configuration values:
•
•
•
•
•
For LINUX or UNIX
a. Enter the following at the command prompt:
tip /dev/ttyb -9600
b. When the terminal application stops reporting information, press Enter to display the login prompt.
c. Log in to the default administrative account using the following identification:
Login: admin
Password: password
d. When prompted either change the administrative password, or press Ctrl-C to bypass.
4. Verify that the switch module has completed POST. When POST is complete, the port status and switch module
power and status LEDs return to a standard healthy state.
5. Enter the CLI ipAddrSet command.
Follow on-screen instructions and supply the correct information, as shown in the following example.
switch:admin> ipaddrset
Ethernet IP Address [10.77.77.77]:10.32.53.47
Ethernet Subnetmask [255.255.255.0]:255.255.240.0
Fibre Channel IP Addresss [none]:
Fibre Channel Subnetmask [none]:
Gateway IP Address [0.0.0.0]:10.32.48.1
DHCP [Off]:
IP address is being changed...Done.
6. Enter ipAddrShow at the prompt to verify that the address was correctly set.
Configuring for FCoE
The initial configuration of the switch has the CEE ports shut down. In order to configure the ports for FCoE
operation, you must access the CEE command shell and configure both the internal and external CEE ports. Once
you have logged into the switch, use the cmsh command to access the CEE command shell. Use the following steps
to configure the CEE ports.
1. Login to the switch.
2. Enter the following command:
cmsh
3. Once in the command shell, enter the following command:
enable
4. Enter the following command:
conf t
Dell M8428-k Getting Started Guide
MHWKY
Downloaded from www.Manualslib.com
Bits per second: 9600
Databits: 8
Parity: None
Stop bits: 1
Flow Control: None
manuals search engine
7 of 160