Instructions For Measurement - IBP BP 131 Gebrauchsanweisung

BP_131_GB.qxd:BP 603 D_neu Kopie

9 instructions for measurement

a) Start the Monitor by pressing the START/STOP key
When the START/STOP key
b)
display functions which is complete after about 1 second. The last reading taken will
appear in the display.
c) The unit is ready for use. The unit will automatically start to inflate slowly to measure
your blood pressure. During inflation, the pressure build-up symbol
display. The unit inflates the cuff until sufficient pressure has built up for a measurement.
When pressure reaches to the proximity of your systolic blood pressure, the monitor will
exhaust cuff pressure. The pressure build-up symbol in the display will disappear; in its
place the pressure reduction symbol
d) While measuring, do not move the cuff or your arm or hand muscles, don't speak. The
cuff will deflate automatically. While the unit determines your pulse frequency, the pulse
symbol will flash.
e)
Once the reading is complete, both the systolic and the diastolic blood pressure, along
with the pulse value, will automatically appear in the display. The measurement values
are automatically stored in the memory. Up to 60 memories can be saved in the Memory
Zone. Pressing the START/STOP key
turn off after about 2 minutes of inactivity.
10
Downloaded from www.Manualslib.com
is pressed, all digits will light up. This is a check of the
manuals search engine
19.04.2007
.
will now appear.
turns off the power. The unit will automatically
16:02 Uhr Seite
will appear in the