Dell PowerEdge 2550 Installation Seite 7

Connect one end of the ribbon-style interface cable provided in your drive upgrade kit
15
to the 10-pin interface cable connector on the fifth-drive board (see Figure 1-4).
Attach the other end of the ribbon-style interface cable to connector DRIVE5 on the
16
main SCSI backplane board (see Figure 1-5).
F i g u r e 1 - 5 . C o n n e c t o r s o n t h e M a i n S C S I B a c k p l a n e B o a r d
power connector (POWER2)
SCSI cable
connector (SCSIA)
data cable connector to optional fifth drive board (DRIVE5)
Connect the spare power cable leading from the power supply distribution board
17
(see Figure 1-1) to the power connector on the fifth-drive backplane board
(see Figure 1-4).
Reconnect the control panel cable, power cable, cooling fan wiring harness, and
18
interposer board interface cable to the interposer board (see Figure 1-2).
Install the fifth hard-disk drive by aligning the edge of the hard-disk drive carrier with
19
the opening in the front of the hard-disk drive cage, and insert the carrier into the
drive cage (see Figure 1-6).
Downloaded from www.Manualslib.com
system-board data
cable connector
(PLANAR)
manuals search engine
SCSI cable connector
(SCSIB)
Instal ling a Fif th SC SI Hard-D i sk Drive
1-5