Cleaning And Maintenance - Ariete 2733 eco power Handbuch

EN
After using the cleaner
Switch off the appliance using the foot switch (F).
Then unplug the appliance from the mains power and hold down the foot pedal (C) on the appliance
until the power cord is fully rewound.
WARNING: While rewinding the power cord, guide it in the right direction by hand to prevent any
risk of injury to yourself.
Put away the appliance, placing the floor brush (O) on the special hook in the back (Fig. 5).
Carrying the vacuum cleaner
Only carry the appliance using the special handle on the top part (G).

CLEANING AND MAINTENANCE

WARNING: Before carrying out any cleaning or maintenance operation, switch off the appliance and
unplug it from the mains power.
The dirt vacuumed up will enter the dust container (A). The air is cleaned by a permanent washable
filter that is located inside the dust container, by a motor protection filter and an air outlet filter located
under the appliance.
WARNING: Never use the vacuum cleaner if any filter is missing or damaged. Any dust cleaned up
will enter the appliance and damage the motor.
WARNING: Clean the filters regularly or in any case, whenever the suction power seems to be
reduced.
How to empty the dust container (A)
- Press the release button (E) and at the same time take out the dust container (A) using the handle
(G) (Fig. 6).
- Empty the dust container (A), opening the lid with the release button (Fig. 7).
IMPORTANT: To empty the container and prevent any dirt from leaking out, we recommend first
placing it inside a plastic bag and emptying it there.
- To clean the container (A) fully, it is necessary to disassemble it completely, as described here
below:
- press the appropriate button and open the lid of the container (A) (Fig. 8); extract the filter beneath
(Fig. 9);
- remove the complete filter by rotating it clockwise (Fig. 10).
IMPORTANT: Wash the filter in clean water without soap or detergents. It is advisable to clean the
filter at least every 6 months or in any case, when suction is visibly reduced.
- Before using the appliance again, reassemble the container (A).
- Place the filter inside the container (A) and lock it into place by turning it anticlockwise.
- Now refit the whole dust container (A) onto the appliance body, pressing gently until it clicks into
place (Fig. 11).
- 10 -