Important Note - Kokido DELTA 200 Bedienungsanleitung

IMPORTANT NOTE:

Detach the brush after use. Otherwise, it may deform due to constant compression, and could interrupt robot movement as a
result.
Adjustment of Trajectory
Locking Pin
The trajectory of the robot is dependent on the position of the pin that fixes the axle to a certain angle. There are two
pins: the one on the right is fixed and should remain untouched. Alter only the position of the pin on left.
Recommended settings:
NOTE: Wheel axle should be positioned above the locking pin
Pin location
1
2
3
1
2
3
Pool size
For pools where the shortest
length is 3 meters or above.
If the robot does not cover the
entire pool with either pin
position 1 or 3, try below setting.
If the situation persists, deploy
the robot from a di erent location.
For pools where the shortest
length is 3 meters or below.
(Factory setting)
6