Getting Started - Kokido DELTA 200 Bedienungsanleitung

GETTING STARTED

Charging The Battery
IMPORTANT NOTE: Fully charge the robot (about 6 hrs) before using it for the first time.
WARNING!
• Use only the original external adaptor and charging plug provided.
• Make sure the robot and the charging port are clean and dry before set-up and charging.
(TIPS: Pry open the protective cover and use a cotton bud to dry the charging port and charging
pins)
• The charging pins are waterproof. However, remnants of water in the port and around the pins
could result in natural occurrence of stains (a byproduct of chemical reaction between water and
electric currents). Otherwise, the stains can be removed by light scrubbing with a cotton bud
soaked with juice of lemon or vinegar.
• Make sure the robot is off by sliding the switch to the OFF position prior to charging.
1. Place the unit on a flat surface. Slide the switch to the OFF position.
2. Pry open the protective cap. Align and attach the charging plug to the charging port.
WARNING! Be sure not to invert the charging plug and ensure both the charging plug and charging
port are clean and dry before charging them. TIPS: Use cotton bud to dry the charging port and pins.
Plug the charging cable of the external adaptor into the charging plug.
3. Connect the external adaptor to the power source. The indicator light on the external adaptor turns
red once the charging begins. The indicator light on the external adaptor will turn green when the
robot is charged.
5-6h
RED light - Charging
GREEN light - Charged
OFF
ON
4