Care, Maintenance And Storage; Disposal Advice - Hudora R 16 Rot Bedienungsanleitung

GB
CONGRATULATIONS ON PURCHASING YOUR SPORTS PRODUCT!
Please read these instructions carefully. The instructions are an integral part of the pro-
duct. Therefore, please store them and the packaging carefully in case questions arise in
the future. Please always include these instructions when you are handing on the product
to a third-party. Children should only assemble, use or repair the product when they are
under adult supervision.
Technical specifications:
Item : Unicycle Balancer R 16 Rot
Item number : 10195
Maximum carrying capacity : 60 kg
Recommended for leg length : 69 - 76 cm
Item : Unicycle Balancer P 16 Pink
Item number : 10196
Maximum carrying capacity : 60 kg
Recommended for leg length : 69 - 76 cm
Item : Unicycle Balancer B 20 Blau
Item number : 10202
Maximum carrying capacity : 100 kg
Recommended for leg length : 73 - 82 cm
CONTENTS:
Before starting to assemble all parts, check whether the package contains all items in the fol-
lowing list: 1x frame with fork and wheel, 2x pedals, 1x seat with seat tube, 1x pedal spanner,
1x stand, 1x instructions for use.
Other components included with the product are not relevant for set-up and use.
WARNING:
This product is only suitable for one person. This product is suitable only for even, paved
areas. Do not use on public roads. Always wear appropriate safety clothing (helmet and
elbow, knee and wrist guards) and do not ride barefoot. Do not ride at dusk, at night or in
poor visibility conditions. To avoid putting yourself or others at risk, do not ride on carria-
geways and in passageways, or on slopes and hills. Uphill or downhill riding should not
be attempted. Avoid riding near stairs and open water. Check your product before every
ride to make sure that all parts are properly attached and that the product works in line
with its intended
use.
ASSEMBLY INSTRUCTIONS:
The product must be assembled by an adult and may only be used under supervision by an
adult. Faulty assembly can lead to injury to the user or other persons. This sports product
is for learning and training balance and physical coordination and is not a toy!
1. We have already pre-assembled the unicycle. Assembly should therefore be rather easy.
Be sure to assemble the pedals on the proper side (they are labelled R and L, as is the
pedal crank on the inside).
2. Insert the seat tube into the frame. Bring the lever of the quick-action clamp into vertical
position and first tighten the nut on the other side by hand, then turn the quick-action
clamp lever back. If the connection is not tight enough, you should repeat this procedure
and tighten the nut further. Loosen the nut a little if you cannot move the lever.
3. Screw the pedals into the thread of the pedal crank. Be sure to assemble each one on the
proper side. Finally tighten them using the enclosed spanner.
4. Inflate the tyre. Keep in mind that your whole body weight will be supported by this one
single tyre, which is why it needs to be inflated more than a bicycle tyre (to a maximum of
2.5 bar).
5. Adjust the saddle to its correct height and position. The wide end goes to the back
(the clamp opening for adjusting the height also goes to the back). Be careful not to pull
out the seat further than the minimum, as indicated on the seat tube. Your stretched-out
leg should reach the pedals in their lowest position. Tighten the quick-action clamp as
described under item 2.
NOTES ON USE:
Should this be your first time to ride a unicycle, you will need a great deal of perseverance, as
learning to ride a unicycle does not happen overnight. As a beginner, you should get two per-
sons to help you by supporting you on your right and left arms while starting out, to give you
a chance to learn to keep your forward/rear balance. Once you can keep your balance, you
can try riding on your own or along a wall for added support. Once you're quite confident
with riding your unicycle, you can try to mount your unicycle freely. At first, it is best to posi-
tion the unicycle next to the kerb, with the right pedal facing backwards and slightly down-
wards. This will prevent the unicycle from rolling backwards at first. When mounting freely
without using the kerb, the rear pedal
should point downwards at a 45-degree angle. Now place the left foot quickly onto the pedal
and drive off. Check that all parts are aligned correctly and tightly before each use, particularly
the axle fitting and the quick-action lever!
ONCE YOU'RE REALLY CONFIDENT WITH RIDING ON THE UNICYCLE,YOU CAN
PRACTISE THE FOLLOWING TRICKS:
Swinging back and forth: when swinging back and forth, you should try to stay on the spot
withthe unicycle. You can hold your balance by holding your arms out straight to the left and
right. Try to swing back and forth in short steps. If one of the pedals is down, you only need
one foot for swinging. This is a good preparatory exercise for one-legged riding.
One-legged riding: before attempting one-legged riding, you should be able to swing back
and forth with only one leg on a pedal and the other leg stretched out or resting on the frame.
For one-legged riding, you have to step on the pedal in front with a little more power and let it
roll without unobstructed. You can find more tips and tricks in specialist books or on the
internet.

CARE, MAINTENANCE AND STORAGE:

Although the product has seat caps to protect the seat when the unicycle falls over, but
you should always use the stand included in the package. To do this, bring one of the
pedals into its lowest position and lean the unicycle with this pedal first against the long
side of the stand. While doing this, the tyre rests against the shorter stand side, lying on
the floor.
Use a dry or damp cloth only to clean the product; do not use special cleaning agents!
Check the product for damage or traces of wear and tear before and after each use.
Store the product in a safe place where it is protected from the elements, cannot be damaged,
and cannot injure anyone.
For your own safety, please use original spare parts only. These can be sourced from HUDO-
RA. Do not make any structural changes.
If parts become damaged or if sharp edges or corners should develop, the product may not
be used any more. If in any doubt, please contact our service team (http://www.hudora.de).

DISPOSAL ADVICE:

At the end of the product's life, please dispose of it at an appropriate collection point provided
in your area. Local waste management companies will be able to answer your questions on
this.
SERVICE:
We make every effort to deliver faultless products. If faults do arise however, we put just as
much effort into rectifying them.
Therefore, you can find numerous information on the product, replacement parts,
solutions to problems and lost assembly manuals at http://www.hudora.de.
You can also contact us by telephone. We will be sure to satisfactorily answer your inquiry
here also: 0700/483672-48.
FAQ's and solutions to many technical problems can be found at http://www.hudora.de
HUDORA GMBH • Jägerwald 13 • 42897 Remscheid
http://www.hudora.de
Art.-Nr. 10195
Art.-Nr. 10196
Art.-Nr. 10202
Stand 07/07
3/6