Kenwood triblade System HDP30 Bedienungsanleitungen Seite 9

Mashers
important
Never use the masher in a
G
saucepan over direct heat. Always
remove the saucepan from the heat
and allow to cool slightly.
Do not tap the masher on the side
G
of the cooking vessel during or
after mashing. Use a spatula to
scrape excess food away.
For best results when mashing
G
never fill a saucepan etc., more
than half full with food.
A A
Plastic Masher (if
supplied)
to use the masher
The masher can be used to mash
G
cooked vegetables such as
potatoes, swede and carrot.
Don't mash hard or uncooked
G
foods - you may damage the unit.
1 Cook the vegetables and drain.
2 Fit the masher collar to the masher
foot by turning in a clockwise
6
direction until it locks in position.
3 Turn the masher upside down and
fit the paddle over the central hub
and turn anti clockwise to secure
7
. (If the collar is not fitted
then the paddle will not
secure in place).
4 Fit the power handle to the masher
assembly - push to lock.
5 Plug in.
6 Place the masher in the saucepan
or bowl etc.
TYPE HDP30 - press the on
button.
TYPE HDP40 - select a low speed
on the variable control and then
press the on button.
Move the masher in an up and
G
down movement throughout the
mix until the desired result is
achieved.
7 After use release the on button and
unplug.
8 Press the blender shaft release
buttons to release the masher
assembly.
9 Remove the paddle from the
masher by turning clockwise.
10 Unscrew the collar from the masher
foot.
B B
Metal Masherpro™ (if
supplied)
to use the masher
The masher comes with two
G
screens which can be used as
follows:-
Coarse screen - to mash
cooked vegetables such as
potatoes, swede, yams and carrot.
Fine screen - to mash cooked or
soft fruits and vegetables.
Don't mash hard or uncooked
G
foods you may damage the unit.
1 Cook hard vegetables and fruit and
drain first before mashing.
2 Fit the masher collar to the masher
shaft by turning in a clockwise
direction until it locks in position
3 Fit either the coarse or fine screen
to the masher shaft – turn
clockwise to lock
4 Turn the masher upside down and
fit the paddle over the central hub
and turn anti-clockwise to secure
bk
.
(If the collar is not fitted
then the paddle will not
secure in place).
5 Fit the power handle to the masher
assembly - push to lock.
6 Plug in.
7 Place the masher in the saucepan
or bowl etc.
TYPE HDP30 - press the on
button.
TYPE HDP40 - select a low speed
on the variable control and then
press the on button.
Move the masher in an up and
G
down movement throughout the
mix until the desired result is
achieved. Increase the speed if
required.
8 After use release the on button and
unplug.
9 Press the blender shaft release
buttons to release the masher
assembly.
10 Remove the paddle from the
masher by turning clockwise.
7
8
9
.
.