Maintenance - Ferm ATM1039 Originalbetriebsanleitung

Keep the nozzle 25 - 30 cm from the surface and
spray evenly from side to side or up and down. Do
not spray at an angle as this will lead to paint runs
on the surface. Use smooth and even strokes.
It is essential that the spray gun is cleaned
thoroughly after every use. Failure to clean it will
almost certainly result in blockages and it may
not operate when you next come to use it! The
guarantee does not cover cleaning a sprayer that
has not been properly cleaned by the user.

4. MAINTeNANCe

Trouble shooting
• S pray gun does not spray / blow gun does
not blow.
• C heck the valve, cylinder and needle of the
nozzle on blockage
• C heck the air hose on leakage
• C heck the air pressure
• " Orange Skin" excessive fogging.
• I ncorrect solvent is used
Use correct solvent.
• S pray gun too far from the surface.
Hold spray gun closer to the object.
• P aint too thick
Thin the paint
faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card.
eNVIRoNMeNT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
GUARANTee
For the conditions of guarantee, please refer to
the separately provided guarantee card.
3