Maintenance; Machine Data; Safety Instructions - Ferm ATM1039 Originalbetriebsanleitung

EN
PAINT SPRAY GUN
Read the safety and operating
instructions of the air tool and the
compressor before using the appliance.
Contents

1. Machine data

2. Safety instructions

3. Use

4. Maintenance

1. Machine data
Technical specifications
Operating pressure
Nozzle diameter
Maximum nozzle flow rate
Container capacity
Weight
2. Safety instructions
Explanation of symbols
In this manual and/or on the machine the following
symbols are used:
Wear protective gloves
Use a spray-mask during spraying
Wear eye protection
Safety instructions
• Avoid too high pressure
• Never blow or spray in direction of yourself or
others; this could cause serious injury.
• Keep bystanders and pets away
• Children and animals should be kept far away
from the area of operation of the machine.
• If you use the compressor to spray paint:
a) Do not work in enclosed spaces or near
naked flames.
b) Make sure that the environment in which
you will be working has dedicated
ventilation.
c) Protect your nose and mouth with a
dedicated mask
• If the compressor is no longer in use, always
take the plug out of the plug socket.
2
• Always make sure that compressed-air hoses
are used for compressed air and which are
characterised by a maximum pressure
adjusted to that of the compressor. Do not try
to repair the hose if it is damaged.
3. Use
Only use the compressor with accessory in a good
ventilated area.
• Connect the PU hose between compressor
and accessory
• Slide the hose-coupler on the accessory until
the coupler clicks. Now the hose is connected
4.5 - 6 bar correctly.
1.5 mm
• To release the coupler, pull the outside ring
6.5 cfm
backwards.
400 cc
0.50 kg
Use paint spray gun
Paint and solvents are very flammable. Therefore
check the following:
• Only spray in good ventilated areas
• Use a spray-mask during spraying
• Avoid open fire and smoking during spraying
• Do not spray in an area with a burning stove
• Never spray with fuel of other flammable
products
• Wear safety goggles
To obtain the best results, it is important that you
prepare the surface to be sprayed and thin the
paint to the correct viscosity, before you operate
your spray gun. Always ensure that the surfaces to
be sprayed are free from dust, dirt and grease.
Make sure that you have masked the areas that
should not be sprayed, using a good quality
masking tape. The paint or fluid to be sprayed
should be thoroughly mixed and free from lumps
or other particles. Many substances can be
sprayed with your spray gun, but always check the
manufacturers recommendations before
purchasing your paint.
To obtain the best results, keep your spray gun
level and parallel to the surface at all times.
Keep the nozzle 25 - 30 cm from the surface and
spray evenly from side to side or up and down. Do
not spray at an angle as this will lead to paint runs
on the surface. Use smooth and even strokes.
It is essential that the spray gun is cleaned
thoroughly after every use. Failure to clean it will
almost certainly result in blockages and it may not
Ferm