Cleaning And Care; Troubleshooting - Klarstein Vita Pure 2G Bedienungsanleitung

Filter Replacement
The POWER light will flashing continuously in GREEN indicating that it is time to replace the filter. Replace the
filter according to the directions then press the POWER/UV-C button and hold for 5 seconds to restart the
system. The light will stop flashing. Filter will last approximately 6 months.
1. Open the front cover from the top.
2. Remove the combination filter by pull the two strips.
3. Insert new Combination Filter into the unit. Consult the strips on the filter for correct installation direction.
4. Reattach the Front Cover of the unit and securely latch into place.
5. Press and hold POWER/UV-C Button for 5 seconds to reset Filter Change Indicator.
Cleaning
• The air purifier should be cleaned at least once every month and the outer Pre-/Activated Carbon Filter
attached to the HEPA Filter should be cleaned every month. More frequent cleaning may be required de-
pending on environmental conditions.
• Clean the Pre-filter and the Activated Carbon Filter with the brush attachment of your vacuum cleaner. This
will remove lint and dirt. NOTE: The Combination Filter is one filter system. The multiple layers include: the
Pre-filter, Activated Carbon Filter and HEPA Filter.
• Use a clean, dry, soft cloth to wipe the external surface of the unit. CAUTION: Do NOT use gasoline, benzine,
thinner, harsh cleaners, etc. on and/or in the unit while cleaning as they will damage the product.
Before carrying out any of the following service checks, unplug the unit from the mains.
Problem
Insufficient air flow.

Cleaning and Care

Troubleshooting

Possible Cause
Check that the filters are clean.
Check for any obstructions in the air inlet and outlet.
10