Life & Mobility vivo Bedienungsanleitung Seite 27

Disassembled mobility scooter
b
D
Unlocking
Settings and adjustments
Adjusting the seat height (3 positions)
1. Remove the seat (see page 29).
2. Remove the battery box; use the handles on
both sides for this.
3. Loosen the bolt and adjust the seat column
to the required seating height.
4. Replace the battery box.
5. Replace the seat.
Dismantling
The mobility scooter can easily be dismantled
for transport or storage (see the 'Transport and
Storage' chapter also).
Warning:
ƒ Be very careful when dismantling the mobility
scooter. Ensure that your hands and fingers
do not get trapped in the hinge system.
Please note:
ƒ The mobility scooter must be secured for
transport after disassembly at the indicated
places.
ƒ The seat can be grabbed from the seat itself
and the back.
ƒ The front part of the mobility scooter has grab
places on the bumper and the seat column.
The rear part of the mobility scooter has a
ƒ
lifting bracket.
1. Remove the seat.
2. Remove the battery box; use the handles on
both sides for this.
3. Pull the unlocking lever (b) on the rear side
of the mobility scooter vertically upwards.
4. At the same time, press the handle (D)
towards the ground.
5. Now, lift the front section (Y) away from the
rear section (Z).
Z
Y
Determining the position
Y
Assembling
EN18
Assembling
1. Tilt the rear section (Z) of the mobility
scooter at an angle of 45 degrees onto the
anti­tipping wheels.
2. Attention:
Determine the hook­in position accurately
to prevent damage to the body shell.
3. Lift the front section of the mobility scooter
and carefully hook it onto the frame tube of
the lower rear section.
Z
4. Allow the front section to lower gently, until
both sections audibly click together.
Z
EN19