Life & Mobility vivo Bedienungsanleitung Seite 23

Safety instructions
scooter.
ƒ Never carry the mobility scooter by the
plastic parts of the housing.
Attention:
ƒ Make sure that the mobility scooter is fully
assembled before use.
Miscellaneous
Warning:
ƒ Do not put the mobility scooter in direct
sunlight: the upholstery can become too
hot, and cause burns or irritation to the skin.
Be careful:
ƒ Never attempt to resolve a fault yourself.
Contact your dealer instead.
Do not allow the mobility scooter to come
ƒ
into contact with seawater: seawater is
corrosive and will damage the mobility
scooter.
ƒ Do not allow the mobility scooter to come
into contact with sand: sand may penetrate
to the moving parts of the mobility scooter,
causing faster wear and tear.
Attention:
A number of technical precautions have been
implemented to further guarantee your safety:
The immobiliser is activated whenever a
ƒ
battery charger is connected.
ƒ In the event of an electronic fault, the
mobility scooter will make a controlled stop.
ƒ To avoid the risk of body parts becoming
trapped, the necessary components have
been guarded where possible.
To secure your body in the correct position,
ƒ
your supplier can fit a hip belt to the
fastening points of the hinge of the seat.
EN10
Safety instructions
EMC-approved
The mobility scooter is approved for EMC (Electro­
Magnetic Compatibility). Tests have shown that
mobility scooters are not sensitive or damaging to
mobile communication equipment and electronically
controlled equipment. Despite this, please be careful
when using the mobility scooter and mobile or
electronic equipment at the same time.
It is also not advised to use the mobility scooter close
to strong electric or magnetic fields as can be found
in industrial environments. If you notice problems,
please switch off the mobility scooter.
EN11