Werbung
The TSM range of active monitors have been designed and voiced specifically for all
stage monitoring applications including electric and acoustic instruments, vocals
and drums, and for DJ use. Cabinets, horns, drive units and crossovers have been
optimised to provide clarity and detail in a focused field. Simple but effective
controls allow intuitive adjustment of the powerful amplifier stages.
All models feature robust, low profile composite wood cabinets and steel grilles.
All have front mounted control panels for quick and easy adjustment during use
with 5 band graphic equalisers to eliminate feedback and ensure clarity. Balanced
link outputs are provided to connect to other active cabs.
This manual contains important information regarding correct and safe operation
of your monitor. Please read it thoroughly in order to get the best performance and
reliability from your HH product.
Unpacking
Inspect the product during unpacking, if any damage is found, notify the dealer you
purchased it from immediately. Be sure to save the carton and all packaging
materials. Should you ever need to return the unit back to the dealer or HH
Electronics, use only the original factory packing.
Basic Setup
TSM monitors are designed to sit on the floor pointing upwards at the user.
Connect a suitable mains lead to the mains inlet on the side panel, and a line level
signal to the input. Set the volume control to minimum before switching on. Adjust
gain levels as desired.
Switching Off
After using the amplifier, please adjust the gain controls to their lowest settings,
then the amplifier can be turned off safely. Turn the power switch to the OFF
position and remove the power cord from the electrical source.
NOTE:
Do not connect or disconnect from the input signal source when the amplifier is
turned ON, damage could occur to the amplifier and the speaker.
Remove the power cord from the electrical source when not in use.
INTRODUCTION
Werbung
