Unpacking; Basic Setup; Switching Off; Introduction - HH Electronics VECTOR VRM-110A Bedienungsanleitung

INTRODUCTION

The Vector range of active monitors has been designed and voiced specifically for
all stage monitoring applications including electric and acoustic instruments, vocals
and drums, and for DJ use. Cabinets, horns, drive units and crossovers have been
optimised to provide clarity and detail in a focused field. Simple but effective
controls allow intuitive adjustment of the powerful amplifier stages.
All models feature robust, low profile composite wood cabinets with tough carpet
covering and steel grilles. All have front mounted control panels for quick and easy
adjustment during use with 5 band graphic equalisers to eliminate feedback and
ensure clarity. Balanced link outputs are provided to connect to other active cabs,
and an additional passive cab (such as the HH VRM passive monitors) can be
powered using the internal power amplifier.
This manual contains important information regarding correct and safe operation
of your monitor. Please read it thoroughly in order to get the best performance and
reliability from your HH product.

Unpacking

Inspect the product during unpacking, if any damage is found, notify the dealer you
purchased it from immediately. Be sure to save the carton and all packaging
materials. Should you ever need to return the unit back to the dealer or HH
Electronics, use only the original factory packing.

Basic Setup

Vector monitors are designed to sit on the floor pointing upwards at the user.
Connect a suitable mains lead to the mains inlet on the side panel, and a line level
signal to the front input. Set the volume control to minimum before switching on.
Adjust gain levels as desired.

Switching Off

After using the amplifier, please adjust the gain controls to their lowest settings,
then the amplifier can be turned off safely. Turn the power switch to the OFF
position and remove the power cord from the electrical source.
NOTE:
Do not connect or disconnect from the input signal source when the amplifier is
turned ON, damage could occur to the amplifier and the speaker.
When the amplifier is connected to the power supply, power is present inside, even
in standby mode where the power switch is in the OFF position.
If the amplifier is in standby mode without use for over 3 hours, remove the power
cord from the electrical source.