Adjusting The Headrest - Kidwell MAVI Benutzerhandbuch

are fi xed adequately tight against the body of the child. Too much freedom or too
little freedom of the harness against the body of the child could result in danger
being posed to the child. Attach the shoulder strap buckles together before they
are connected by the central adjusting button. When connecting all of the straps
together you should hear a "Click" sound signifying that the harness has been
fastened properly.
D. While pushing the central adjusting button, gently pull the strap right next to the
button. Remember that the harness has to be in adequately close proximity against
the body of the child, however, not in such close proximity that would cause any
type of discomfort to the child. For this reason, it is not recommended for the child to
wear thick clothes and many layers of clothing as the distance between the harness
system and the body of the child could be distorted.
E. The belts have 2 possible heights, remove the belts from the connector (see
schematics, drawing 15), then pull them out of the slot and insert them into the
height appropriate for the child. Reconnect the belts with the connector. Remember
to make sure that the height is suitable for the child's height.
ATTENTION: when moving belts to other heights, make sure they are not twisted.
This can cause the belts to malfunction.

ADJUSTING THE HEADREST

5
The headrest has a round button that, when pressed, allows you to adjust it.
After releasing the button, the headrest will lock at one of the available height positions
WARNING: After releasing the adjustment button, make sure that the lock is active
WARNING: Check regularly whether the headrest fi ts the child's height.
REMOVING 5-POINT BELTS
6
A. Loosen the belts by pressing the central adjusting button, which is located in the
middle of the seat, under the seat cover (see schematics, drawing No. 3). Press the
button and pull the chest straps to extend them.
B. B. Remove the straps from the connector (see schematics, drawing No. 15) and
pull them out through the slits. The next step is to remove both buckles by sliding
them to the end of the belt. Then pull one of the belts (left or right) to remove them
from the seat frame.
C. The connector is a part of the central adjustment mechanism. Press the adjustment
button (see schematics, drawing No. 3) and pull the belt out by the connector.
D. To remove the central belt buckle, put the seat on its side to access the underside
and remove the belt clip.
REMEMBER: all parts of the belts should be put in a safe place and kept for future use.
To reinstall the belts, follow the instructions „REMOVING 5-POINT BELTS" in reverse
order.
25