Error Codes - Steelcase Migration SE Kurzanleitung

5.6 Resetting to factory settings (up/down, operator panel)
This function can be used to reset the DM-system to its factory settings.

Briefly press the buttons shown below simultaneously:
a "Down" button
b "Up" button

Simultaneously press and hold the buttons shown below until the red lamp goes out at the
signal lamp:
a "Down" button
b "Up" button

Wait until the signal lamp starts to rapidly flash green; then press and hold the "Down" button
until the desktop has reached the lowermost "Block" position.
There is a sound that will fade away (the generated scratching noise is normal and
=
presents no sign of damage).
The DM-system has been reset to its factory settings.
=

6. Error codes

Error codes are always indicated on the display with an "Err" for error followed by a number. The most
common error codes are also provided with an extra function such as "HOT" or "ISP".
The most important error codes:
A complete list of error codes can be found in the detailed User Guide
(www.steelcase.com/eu-en)
7. Service and contact details
Manufacturer
Steelcase AG
Brienner Str. 42
80333 München
145521
HOT OVERHEATING
ISP COLLISION
CON / Err CONNECTION ERROR
Err / 1 and 21 FIRMWARE
Err / 2 MOTOR OVER CURRENT
Err / 3 DC OVER VOLTAGE
Err / 12 POWER STAGE OVERCURRENT
Err / 14 CRITICAL DC OVER VOLTAGE
Err / 17 ERROR WITH PAIRING
Err / 18 INCOMPATIBLE DRIVE UNITS
Err / 19 TOO MANY / TOO FEW DRIVE UNITS
Err / 22 POWER UNIT OVERLOAD
Phone: +49 (0) 80 31 405 – 111
E-mail: DE lineone-de@steelcase.com
EN lienone-en@steelcase.com
FR lineone-fr@steelcase.com
ES posventaspain@steelcase.com
Migration SE
EN
Rev. C