Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Outdoor Siren with flasher HP600
Component identification
1. Mounting holes
2. CC input terminal board
Not used.
3. Power switch
The switch comprises 3 positions:
BT4: the siren is powered by a configuration with 4 alkaline batteries.
Off: the siren is not battery powered.
BT2: spare configuration.
4. LED group 3
5. LED group 2
6. Cover fixing screw
7. LED group 1
8. Configuration dip switch
9. Learning button
10. Battery housing
11. Tamper switch
12. Base
Supervision
In normal operating mode, the siren transmits a supervision signal at constant
intervals. If the signal is not received, the control unit will indicate a supervision
alarm.
Dip switch Configuration
The Dip Switches are used to determine the different functions of the siren.
When the switch is moved to "ON", the switch is ON. When the switch is OFF it is moved to the opposite part.
The functions of each Dip Switch of the functional switch block are shown below:
SW1
SW2
OFF position
ON
SW3
SW4
OFF position
OFF position
OFF position
ON
ON
OFF position
ON
ON
SW5
SW6
OFF position
OFF position
OFF position
ON
ON
OFF position
ON
ON
SW7
OFF position
ON
For more details see paragraph Function overview.
DS80HP8A-001E
Reserved
Light alarm activation (LED groups 1-2-3)
Only during the acoustic alarm (default)
Until the system is deactivated
Alarm time
3 minutes (default)
5 minutes
10 minutes
1 second (sounded TEST use)
Volume control: siren sound, exit/entrance confirmation/delay
sound
Reserved
Down
Medium
High (default)
Chime function (not managed on MP500/xx systems)
Off (default)
On
8
9
7
Werbung
Inhaltsverzeichnis
