Operation - Ryobi ELT-3725 Bedienungsanleitung Und Sicherheitshinweise

GB
F D E
ADJUST THE TRIMMER TO A COMFORTABLE
OPERATING POSITION
1. Press in the pump-button and turn the shaft to
a comfortable operating angle.
2. Move the lock button in the direction of the cutting
unit and adjust the shaft length in or out to suit.
3. Loosen the adjuster screw and move the second
handle vertically and horizontally until you are holding
the unit firmly.
4. Move the clamp towards the handle to rotate the
motor body into the desired operating position.
Connecting an extension lead:
Attach an extension lead approved for outdoor work
to the cable on the trimmer. Locate it in the retainer
as shown in Fig. 3.
ADJUSTING THE CUTTING LINE
Check the cutting line before you switch on the trimmer.
It should be long enough to reach the line cutter.
If necessary, push in the knob and pull the line out to the
appropriate length.
SWITCHING YOUR TRIMMER ON/OFF
Plug in the extension lead and hold the trimmer in the
operating position.
Switching on: Hold the trigger switches in the handle
so that both can be squeezed simultaneously.
The triggers must be operated together for the
trimmer to switch on.
Switching off: Release the triggers. The trimmer will
switch off automatically.

OPERATION

After switching the unit on, let it run for a few seconds
before cutting any grass. The cutter will automatically trim
both lines to the correct length. Now you can start cutting
the grass.
Worn lines will produce an unsatisfactory result. Tap the
head lightly on the ground from time to time to feed out
new lengths of line.
I P NL S DK
English
TIPS
-
-
-
-
-
-
CHANGING THE LINE SPOOL (FIG. 4)
Unplug the power cord! Press in both locks, then remove
the spool cover. Take out the used spool and clean off
any compacted dirt or grass.
Feed the ends of the line from the replacement spool
through the line outlets in the spool holder.
Locate the replacement spool on the spring in the holder,
making sure that you do not snag the lines. Replace the
spool cover and snap in into place. Proceed as described
under "Adjusting the cutting lines".
CARE AND MAINTENANCE
Unplug the power cord! Remove any dirt or grass from
the motor housing, guide roller and line guard.
If necessary, use a damp cloth. Do not use solvents.
Dry thoroughly.
Make sure the ventilation slots are always clean.
ENVIRONMENTAL PROTECTION
Take unusable equipment and packing materials for
recycling in accordance with local regulations.
6
N FIN GR H CZ
Always switch the unit on before making contact with
the grass.
Slowly move the trimmer from right to left at
a 30º angle.
Cut high grass in several stages.
Do not attempt to cut damp or wet grass.
Do not overload your trimmer – always operate it at
maximum revs.
Do not let the line come into contact with rocks,
stonework or fences. The guide roller is designed to
make working near fences and walls easier.
WARNING: Do not lose the loose steel spring.
RUS RO PL