Drain/Overflow Fitting With A Adjusting Knob; Overflow Protection Adjusting Knob - HOESCH Reviva Montage- Und Bedienungsanweisung

Maintenance
Additives for bathing containing solids, such as turf, oils, etc., cannot be used.
After a bath rinse the bathtub surface with water and wipe it with a wet cloth. Do not use scrubbing agents! When
occasionally cleaning the bathtub thoroughly, spread a couple drops of the cleaning agent on the surface and wipe it with
a soft cloth. Remove heavier dirt using warm water and a mild liquid cleaning agent, or soap water.
Calcifications should be removed with the use of lime removing vinegar and water (do not these use for fittings!). In case
of using the agents for cleaning drains please observe the usage instructions!
Small scratchings or fragments of the shiny surface that have lost their smoothness should be removed with the use of e.g.
the HOESCH maintenance set, article No.: 6991 00.
GB
Tip:
Fittings and built-in elements should be cleaned with a soft cloth. Damages caused as a result of improper usage of chemi-
cals, acids and scrubbing agents will not be taken into consideration by us as the reason of a complaint.
18.01 Drain/overflow fittings with an adjusting knob
Cleaning/maintenance with the use of an M4 hexagon socket screw key
Drawing
Drawing
Drawing
18.02 Overflow adjusting knob
Close the drain
30
1
Drawing
5
Drawing
9
Drawing
Open the drain
2
Drawing
M 4
6
Drawing
10
Drawing
3
Drawing
7
Drawing
11
Drawing
4
8
12