Exchange Of Batteries; Keyboard (Additional Equipment); Functions; Automatic Switching Off Of The System - HOESCH Reviva Montage- Und Bedienungsanweisung

16.01

Exchange of batteries

For exchange of batteries
16.02

Keyboard (additional equipment)

GB
16.03

Functions

After reaching the minimum water level, the whirl tub is ready to work. The ready to work/standby status is indicated by the
green LED diode.
1 Whirl system ON/OFF Press the button
short. After switching the Whirl system on
the pump starts working with full power, and
next it automatically lowers the power by
half.
2 By permanently pressing the +/- buttons you
can individually adjust the power.
By pressing/holding those buttons we de
crease or increase the pump power.
4 Airsystem ON/OFF Press the button short.
After switching the Air system on the blower
switches on slowly to the medium power
level.
5 By permanently pressing the +/- buttons you
can individually adjust the power.
By pressing/holding those buttons we
decrease or increase the blower power.
3/6 interval mode ON/OFF
With the active interval mode the massage
power changes periodically from the lowest
to the highest.
In order to stop the interval mode press the
buttons again.
16.04

Automatic switching off of the system

The operational time of the system is limited to 25 minutes. After 25 minutes, regardless of the buttons switched on, the sys-
tem switches off automatically. By pressing button 1 and/or 4 you can switch the system on again.
16.05

The same frequencies

The functioning the the remote control may locally interfere with other installations or devices working at the same fre-
quency. In order to eliminate the possible sources of interferences the remote control of the whirl tub is limited to
approx. 1.5 m. This distance may change as a result of external influences on the remote control.
28
see a separate leaflet!
7 Plus Airsystem ON/OFF
Can be additionally switched on and off
with Whirlpower + Air.
8 Whirlpower ON/OFF
Can be additionally switched on and off in
the Whirl mode.
9 Underwater LED spotlights ON/OFF
With the coloured LED spotlights – after
pressing the button white colour is on.
Pressing the button again changes the col-
our into blue, green, red, yellow. Pressing
the button again starts an automatic
sequence of colours starting from red.
When the desired colour is reached, press
the button again to stop the sequence at
that colour. Pressing the button again starts
the colour sequence afresh. In order to
switch the option off hold the button for
approx. 4 seconds.
10 Starts semi-automatic disinfection, hold the
button for min. 3 seconds.
11 Switch off everything
switching all functions off
12 LED display green, yellow, red instead of
display module