Setup; Installation; Sound-Control; Connection With The Dimmerpacks - EuroLite LCD-4 Bedienungsanleitung

Rear panel:
16) Audio input socket
17) Analog output socket
18) DMX output socket
19) Power supply socket

5. SETUP

5.1 Installation

Install the device on a plane surface or install it in rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

The sound-control works via the built-in microphone or via the sound input socket.
For selecting the signal source:
When turning the unit on, press and hold the Prog Select-button and switch between E and I via the Mode-
Select-button.
Connect the sound-signal from the mixer (e.g. Master 2) with the RCA-socket on the rear panel (input
sensitivity 0.1 V - 1 V).

5.3 Connection with the dimmerpacks

DMX-512:
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Building a serial DMX-chain:
Connect the DMX-output of the LCD-4 with the DMX-input of the nearest dimmerpack. Always connect one
output with the input of the next fixture until all fixtures are connected.
14/30 70064590_V_1_5.DOC