Electrical Connection - Electrolux CX-L-410-Serie Montage- Und Gebrauchsanweisung

3.4 MOUNTING THE ISLAND COOKER HOOD WITH EXTERNAL CHIMNEY
The island cooker hood is intended to be mounted either directly on the kitchen ceiling or onto
a stable false ceiling structure.
Check that the minimum distance between the bottom of the hood and the upper part of the
hob is in conformity with indications in par. 2.1.
•
Mark the centre of the position on the ceiling at which the hood will be mounted;
•
according to the technical drawing, mark on the ceiling the position of the fixing points;
•
using a drill suitable for building materials, make the fixing holes and insert plugs so that
they are flush with the ceiling;
•
Mount the support structure to the ceiling FIG.9;
•
Fix the upper chimney to the support structure FIG.10, by means of 2 screws;
•
insert the lower chimney to the exterior of the upper chimney, blocking it by strong tape in
a way that the chimney cannot possibly fall FIG.10;
•
insert the cooker hood in the support frame and screw it at the established height. FIG.10.
If the hood is not properly aligned, after loosening the 4 screws on the ceiling, it can be
rotated in the longitudinal holes: finally tighten the screws;
•
connect the pipe;
•
connect the hood to the electricity supply (par. 4);
•
push down the lower part of the chimney with extreme caution so that no scratches can
be produced on the upper chimney.
3.5 GENERAL WARNING
The pipe must be heat, flame and corrosionproof. We strongly advises against the use of
reducers or pipes with different diameter to the hood outlet pipe, and pipes made of flexible
aluminium because performance is diminished and noise level increased.
The end part of the pipe, on the outside of the hole on the wall, must be of such a shape to
avoid rain, gusts of wind or other foreign bodies getting into the pipe. Should there be any
doubt, contact anyone specialising in the installation of gas or ventilation system.

4 ELECTRICAL CONNECTION

4.1 WARNING
The electrical connection can only be carried out by qualified professional personnel, using
standard material and state of the art installation methods. The manufacturer declines any
responsibility for installations carried out by unskilled persons and for installations which are
not in conformity with the standard norms concerning electrical safety (both concerning
methods and materials).
4.2 ELECTRICAL TECHNICAL DATA
The electrical technical data are visible inside the hood after the removal of the grease filters.
4.3 CONNECTION TO THE POWER SUPPLY
The flexible feed cable supplied is already connected internally and emerges from the hood
near the air outlet duct.
It is possible to effect two types of electric installation:
•
fixed installation;
•
installation by means of plug on a socket.
28