Electrolux CX-L-410-Serie Montage- Und Gebrauchsanweisung Seite 31

... to find out how clean the fat filters are, press the O and
display, a number between 0 and 9 will appear, the smaller the number, the dirtier the filter is;
... to find out how worn the carbon filters are, press the buttons O and
number between 0 and 9 will appear, the smaller the number, the more worn the filter is.
7.1.3 TO PUT THE GREASE AND/OR CARBON FILTER CONTROL BACK TO ZERO:
•
stop the motor (stop position);
•
push the push-buttons 0 (zero) and T (timer) at the same time for a few seconds. This
symbol appears
7.1.4 SETTING THE SUCTION /FILTERING USE OF THE HOOD
The hood is delivered standard for suction use (only with flashing F letter). If you wish to use it
in the filtering version (F and C flashing) proceed as follows:
press the buttons
appear followed by a 0.
•
At each pressure of the Light Button, it is possible to change the value shown from the O
(suction function), to 1 (filtering function) and viceversa.
•
Press the O button (zero) to confirm the choice effected in the previous point.
7.2.1 SOFT TOUCH CONTROLS WITH PUSH BUTTONS SCREENPRINTED ON S/STEEL
(FIG.11b)
WARNING ! To activate the functions connected to these push buttons, it is necessary
to apply a little pressure just lightly and for a short time. If pressure is too lengthy on
the push buttons the connected functions are not activated.
The functions activated by the push buttons are as follows:
LIGHTS: switch the lights on and off;
O
MOTOR OFF: turn the motor off;
-
reduces the motor speed;
+
increases the motor speed;
TIMER: if pressed when the hood is already functioning with 1st, 2nd, 3rd or 4th
speed, the led point connected with the selected speed, starts to flash for 10
minutes, after which motor automatically stops.
MEANING OF THE LED POINTS: if the leds connected with the speeds are flashing, there is
a timing running.
5th and 6th Speed must be used just for short periods as the hood is taking in a big quantity
of air so after 10 minutes the motor is automatically reset to the 3rd speed.
7.2.2 AUTOMATIC CONTROL OF GREASE AND CARBON FILTER
the electronic controls with led points allow automatic control of the grease filters and carbon
filters (only in case the hood is used in filtering version) so that the user does not have to
remember when maintenance was last carried out.
above the timer push button keeps on flashing.
and a "bip" is issued.
T
and on the display for about 5 seconds, the following symbol
-
buttons at the same time. On the
1st Speed;
2nd Speed;
3rd Speed;
4th Speed;
5th Speed; led point is flashing;
6th Speed; led point is flashing.
When the grease filters require
cleaning, an acoustic signal is issued
for some seconds and the led point
+
. On the display, a
will
31